Skip to main content
Use a Voice Connector in the Amazon Chime SDK console to route an AWS phone number to a Famulor assistant and place calls through AWS. You need an AWS phone number assignable to the Voice Connector and permission to edit both.

Send incoming calls to Famulor

  1. In Famulor, open Settings → Phone numbers → Add a number → Add SIP integration. Choose a SIP region and copy the hostname from the SIP URI.
  2. In the Amazon Chime SDK console, open Voice connectors and create or select a Voice Connector in the region you will use. Enable Encryption for TLS and SRTP.
  3. Under Origination, enable the route and add the Famulor hostname as Host, port 5061, with TCP. With encryption enabled, AWS uses TLS over TCP for signaling. Copy the connector’s Outbound host name for the Famulor form.
  4. In Phone numbers on the connector, choose Assign from pool, select the number and assign it. Voice Connector settings · Assign AWS phone numbers.

Allow Famulor to place calls through AWS

  1. In AWS, enable Termination. In Credentials, add a username and password. In Calling plan, allow the countries you need. If you configure Allowed hosts list, add the Famulor outbound source addresses for the Outbound region you will use.
  2. In Famulor, choose Phone number (DID) and enter the AWS number in +E.164. Select Provider source IPs and enter the SIP-signaling networks AWS publishes for the connector’s region. AWS Voice Connector network requirements.
  3. For Termination address, enter the connector’s Outbound host name. Set Outbound authentication to username/password with the AWS termination credentials. Enable Secure trunking to match the connector’s encryption settings.
  4. Save and assign the number to an assistant.

Test both directions

Call the assigned number externally. Confirm the call appears in History with the right assistant and two-way audio. Place a separate outbound test call. If AWS returns 403, check the termination credentials, any source-IP restrictions and the calling plan. If a call connects with no audio, check the TLS and SRTP settings at both ends.